冲击台 Shock Tester
一、相关标准测试要求 Test requirements
1.IEC62133-2012
2.UL1642
3.UN38.3
4.GB31241-2014
冲击台 Shock Tester 一、相关标准测试要求 Test requirements 1.IEC62133-2012 2.UL1642 3.UN38.3 4.GB31241-2014 二、主要技术参数 Main Technical Parameters二、主要技术参数 Main Technical Parameters
型号 Model |
BE-IS200 |
|
额定负载 Specified load |
10 kg(含夹具、试验件)fixtures, test pieces are included |
|
台面尺寸(长×宽) Bench Dimension |
200×200 mm |
|
冲击波形Pulse Wave: |
半正弦波Half sinusoidal wave |
|
峰值加速度(半正弦波) Shock Impact Peak Acceleration |
150~15000 m/s2 |
|
脉冲持续时间(半正弦波) Pulse Duration Time: |
0.6~20ms |
|
外形尺寸(长×宽×高) External Dimension |
1000mm×500mm×2700mm |
|
设备重量 Weight |
1500 kg |
|
冲击形式Impact form |
自由跌落Free fall |
|
最大跌落高度Max. drop height |
1500mm |
|
电 源 Power Supply |
三相380V,50/60 Hz Three phase 380V,50/60 Hz |
|
液压源Hydraulic source |
随机配置 With the equipment |
|
环境条件 |
温度(℃)Temperature |
0~40 |
Condition |
湿度(25℃)Humidity |
<85% |
可靠性 reliability |
平均无故障积累工作时间≥1000h; Average failure-free accumulation working time ≥ 1000h; 半正弦波形发生器连续冲击次数不小于5000次; The half-sine waveform generator has no less than 5000 consecutive impacts; 半正弦波形发生器的在干净、常温环境下的存储时间不小于5年。 The half-sine waveform generators have a storage time of no less than 5 years in a clean, room temperature environment. |
|
测控系统 Testing system |
ShockDAQ冲击、碰撞测量控制系统 Impact, collision measurement control system |
|
适用标准 Usage standard |
GJB150、GJB360、GJB548、GB/T2423、GJB1217、JJG497、GIEC68-2-27 |
|
检定标准 Testing standard |
加速度幅值、脉宽、均匀度和横向运动比满足JJG541-88的要求。 Acceleration amplitude, pulse width, uniformity, and lateral motion ratio meet the requirements of JJG541-88. |